[. . . ] Number keys 0 to 9: these keys have the same functions as those of your original remote control and are used to enter the codes of your different sets. When videotext is active, these coloured keys can be used to select headings, depending on the set's make. [. . . ] While the indicator is lit, enter the first digit of the 3-digit code proposed for the set to be controlled (example: 016 for THOMSON). The red indicator then goes off or flashes, if the code is not on the list. Direct the remote control towards the set and try to switch it off by pressing the key B (1). Check of the programming In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the key SETUP/SHIFT (20) until the red indicator lamp (12) remains lit. Direct the remote control towards the set and try to switch it off by pressing the key B (1). Should the set not switch off, press key B (1) as many times as required (up to 200 times), until the set switches off. Between two subsequent key depressions, give the red indicator lamp (12) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming In principle, your set is ready for receiving the remote control commands. [. . . ] If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. [. . . ]